High-performance	Reliability
Ease of use	Value for money

* Pass thread end, from inside, through small hole in rim of bobbin. * Place bobbin on spindle and push it to the right * Holding thread end, step on speed controller to run machine until desired amount of thread is wound. (Winding stops automatically once bobbin is full. ) * Slide spool cap (2) firmly over rim of spool to prevent * Cut thread; push bobbin to the left and remove it from spindle. thread tangling. * Lead thread from spool and snap into thread guide post (3). * Wind thread clockwise around front of bobbin winder tension disc (4). * Trim thread end from top of bobbin. * Return hand wheel disc to sewing position by pressing on side opposite indent. 14 5, 6, 8, 10 Stitch Sewing Machines Inserting a bobbin To insert a bobbin, follow the instructions below: * Raise presser foot * Turn hand wheel toward you until needle is in its highest position. * Open slide plate and remove empty bobbin. Pull 4" (10cm) of thread from replacement bobbin and insert bobbin into case, as shown. Holding bobbin in place, guide thread into notch (1) and then down the slot to the left and guide around into notch (2). Draw several inches of thread diagonally across the bobbin toward the back of the machine. While holding thread on outside, close the slide plate, allowing thread to extend through the slot between the slide plate and needle plate. * Follow directions for "Raising Bobbin Thread" 15 5, 6, 8, 10 Stitch Sewing Machines Threading the machine To thread your machine correctly, follow the steps below: * Raise take-up lever (6) to highest position by turning hand wheel toward you. * Raise presser foot to release thread tension. * Place spool of thread on spool pin (1). and with only one hand pass the thread under the guide and through the slot, as illustrated (4). * Thread the tension discs by leading the thread down and around the tension (5)...